The 9-volt battery maintains clock and alarm settings, and operates the Wave® radio/CD’s backup alarm system for up to 24 hours, during a power loss or while the system is temporarily unplugged. Operating without this battery leaves the memory unprotected, but will not harm the product.
Replacing the system battery
適用対象:
Use a standard 9-volt battery (IEC 6F22 in Europe), available at most retail stores. Use an alkaline battery for longer backup time.
To install the battery, follow these steps:
Note: The battery does not provide functional power for the Wave® radio/CD. It only provides enough power to retain settings, along with a backup alarm. The display will not operate on battery power only.
Carefully turn your system upside down, holding the CD door shut
Press the arrow on the cover to slide the compartment open
Snap the terminals firmly together
Slide the cover closed
Turn the system right side up
To maintain your Wave® radio/CD’s memory and backup alarm system, replace the 9-volt battery every year or whenever you have an extended power loss. You can also check the level of the installed battery to determine if it needs changing.
To check the low-battery indicator, follow these steps:
Turn the system off
hold down alarm setup and press cd stop. the display indicates the remaining battery power:
